A clogged sewer line can bring an entire plumbing system to a stop. When the main line is blocked, drains throughout the home may slow down, gurgle, or begin backing up because wastewater has nowhere to go. This Spokane sewer line call involved a blockage that required mechanical clearing with a cable machine. The material…
Details
Homes left vacant during freezing weather can develop plumbing problems that are not immediately obvious until the water system is turned back on. This repair involved multiple copper pipe failures caused by winter freeze damage inside a home on Spokane’s South Hill. Once temperatures drop low enough, water trapped inside plumbing lines can expand and…
Details
Water heater leaks in multi-unit buildings need to be handled quickly to avoid affecting surrounding units. This repair involved a leaking connection on a water heater serving an apartment near the medical district in Spokane. The source of the issue was not the tank itself, but a fitting that had begun to fail and allow…
Details
A leaking water heater is often a sign that the system has reached the end of its service life. In this case, the existing unit was removed and replaced with a new Bradford White self cleaning water heater to restore reliable hot water. Along with the replacement, a thermal expansion tank was added to help…
Details
Leaks under a concrete slab are not always visible from the surface. In many cases, the only signs are subtle, such as temperature changes or minor moisture that does not immediately point to a specific location. This project involved locating a hidden cold water leak beneath the slab inside a residence using infrared imaging technology.…
Details
Commercial kitchens depend on plumbing that can keep up with constant use. This project on Garland in Spokane involved completing a full kitchen setup designed around multiple sink stations and a layout built for efficiency. Each part of the system needed to support daily operation without slowing things down, from water supply to drainage and…
Details
Not all leaks are constant. Some only show up under certain conditions, which can make them harder to track down. This service call involved water appearing intermittently under a cabinet in a commercial setting, with no obvious source at first glance. Situations like this often require a closer look at components that only activate during…
Details
A leaking water heater can escalate quickly, especially when the source is not just a loose connection but a failure inside the tank itself. In this Spokane Valley home, the issue was traced back to a ruptured water heater that could no longer hold pressure. Once a tank fails like this, repair is no longer…
Details
A kitchen faucet upgrade can completely change how a sink is used day to day. In this case, an older unit was removed and replaced with a Fisher commercial faucet designed for higher performance and flexibility. What changed with the new setup The previous faucet had limited reach and had begun to show wear. After…
Details
When a sewage ejector pump fails, the signs usually show up before the cause is obvious. Drains slow down, fixtures stop clearing, and water begins to back up where it normally would not. In this case, the issue came down to a pump that was no longer cycling. With systems like this, everything depends on…
Details
In busy commercial environments, even a small sink leak can turn into a constant annoyance. This Spokane job focused on a sink that had started leaking at the drain, something that tends to get worse the longer it is left alone. The issue came down to a worn basket strainer. Over time, seals break down…
Details
A clogged urinal in a Spokane commercial setting turned out to be more than a typical blockage. What appeared to be a standard service call required a full system cleanout after the source of the problem was identified. What was causing the clog Upon inspection, the urinal and connected drain line were found to be…
Details
Older drainage systems can develop leaks over time, especially when original materials begin to wear down. In this Spokane Valley project, a section of aging copper drain piping had started to fail, leading to an active leak that needed to be addressed. Why older copper drains start leaking Copper has been used in drainage systems…
Details
In-floor hydronic heating systems are designed to operate quietly and efficiently, but when a leak develops, it can quickly affect both performance and reliability. This Liberty Lake project involved diagnosing and repairing a leaking section within the system’s manifold. Where the problem started The leak was isolated to a section of the manifold that had…
Details
A call for no hot water in a Coeur d’Alene home quickly turned into a deeper plumbing issue once the system was inspected. What initially appeared to be a simple failure was actually the result of improper installation that had been causing damage over time. What caused the failure The water heater had been connected…
Details
Click Here to Call Now
4.7 Google Rating